Acoustic Resilient layer for under screed isolation UK
Acoustic Resilient layer for under screed isolation UK
Acoustic Resilient layer for under screed isolation UK Acoustic Resilient layer for under screed isolation UK Acoustic Resilient layer for under screed isolation UK Acoustic Resilient layer for under screed isolation UK Acoustic Resilient layer for under screed isolation UK
Acoustic Resilient layer for under screed isolation UK
ISO-SCREED RESILIENT LAYER
USES:
  • Impact reduction under screed
  • Suitable for Concrete floors
  • Exceeds New Part E Building Regs
    		•  BENEFITS:
  • Provides significant reduction in impact noise and vibration
  • Easy to cut rolls
  • Very Flexible
  • Simple installation
  • Light weight
  • Low cost
  • Does not significantly increase the floor level

    • ISO-SCREED (Part Code A320)
    Iso-Screed is a 5mm foamed polyethylene layer of 33Kg/m³ density. Used in conjunction with the appropriate floor materials it meets Approved Document E requirements for an underscreed resilient layer. Giving added value of water resistance. It can also protect the mineral wool during screed laying.

    ISO-SCREED significantly reduces impact noise and vibration under floor screed as well as providing a degree of airborne and thermal insulation.

    This product can also be used on top of a concrete floor especially if the floor has failed an impact sound test. If the product is bonded down impact improvements in the order of:
    Impact Sound Improvement Index ISO Method 140 part8 - Delta Lw.34dB
    can be expected.

    		Acoustic Resilient layer for under screed isolation UK

    Section 3.65 of the Building Regulations (Approved Document E) states that the resilient material should meet the following two requirements:

    1. A maximum dynamic stiffness (measured in accordance to BS EN 2905201:1992) of 15MN/m³
    and
    2. A minimum thickness of 5mm under the load specified in the measurement procedure of BS EN 29052-1:1992, 1.8kPa to 2.1kPa.

    ISO-SCREED meets both these requirements.

    In any construction height is a significant factor. This material is designed to ensure maximum performance whilst minimising height rise of the construction.

    Download PDF
    Download INSTALLATION DETAILS
    PLEASE NOTE: Failure to follow the exact wall junction detail will cause an acoustic failure !
    GENERAL PHYSICAL DATA
    Roll Size-30m x 0.925m
    Thickness-5mm
    Density-33Kg/m³
    Dynamic Stiffness-14MN/m³


    All information contained in these details is given in good faith but without warranty.
    Custom Audio Designs reserves the right to alter the specifications of any product without notice.

    ©Custom Audio Designs 2006