INSTALLATION TO WALLS
Panels are fixed with contact adhesive. This is a simple and strong adhesive system for bonding the panels to walls or ceilings. Panels can be applied direct to concrete , brickwork, wood, plaster or metal. There is an immediate bond, therefor no mechanical support is required or the need for drilling any fixing holes.

SURFACE PREPARATION
The wall or ceiling must be clean, dry and free from loose paint, plaster, dust etc. Wallpaper should be removed, gloss paint roughened and emulsion paint brushed with a stiff brush to ensure it is firm. On absorbent surfaces an initial priming coat may be necessary and should be allowed to dry for at least 30 minutes before applying the bonding coat.

FIXING PANELS
Mark the position of the panels on the wall. Apply an even brush of contact adhesive (approx. 100mm wide x 200mm long strips) on the wall to coincide with the perimeter edge on the rear of the panel at maximum of 900mm centers and allow to touch dry for about 15 minutes. Also apply an even brush coat of adhesive on the corresponding positions on the back of the panel so they coincide with the positions on the wall. Allow to touch dry (10-15 minutes). Carefully position the panel, fit one corner first, then aligh vertically and horizontally. Apply even, firm pressure along the lines of the adhesive positions. The panels must be carefully positioned as once contact is made they cannot be readjusted.